Tips on Downrigger Fishing (back)

Keep a good bend in your rod while fishing. There is a moment of slack when a fish hits and a bent rod will take up this slack as the release clip lets go. Watch for your rod tip bouncing slightly as you get nibbles and hits. The PowerGrip Plus release system keeps a slight angle on the snap so that you can see this action.

Be prepared to change your lures or bait if you don't see any action. Ask other anglers what they are using and check with local shops to see what is selling the best for your area. Use sharp hooks and always check your local regulations for limits and restrictions.

Check your gear for weed and small fish every 1/2 hour. Pull rods one at a time to keep a lure in the water while you reset.

Trolling in a lazy zig-zag pattern will often increase strikes due to the increased coverage. This motion also affects your lures as your turn slows the inside line and speeds up the outside, creating a variety of motion to attract fish. You can also change your trolling speed to change the action of your gear. Try to select lures with action appropriate for your trolling speed to get the most our of their design.

Use tidal action to your advantage instead of fighting it. Fish with a fast running tide to the end of your tack, pull your gear and repeat from your starting point.

Try to practice catch and release. Handle fish as little and as gently as you can, leaving them in the water if possible. A fish which is bleeding from the gills should be considered part of your daily limit.

Some anglers use small bells on the end of their downriggers to indicate a strike or a snag. These can be very useful, especially when fishing solo.

Always attach your fishing rod and reel to your downrigger while your boat is in forward motion. This helps avoid tangles.

Not the reading on your depth counter on your downrigger when you catch fish, then return to that depth for best success.

Use caution to prevent downrigger wire from becoming tangled in your prop. Mount your downrigger so that even in sharp turns the wire does not go under the boat. Consider the use of a prop guard to eliminate tangles and cut lines.

Keep your fingers away from the underside of the downrigger base and remove the lead weight when the downrigger is tilted up or unattended. Be sure to use the red lock lever properly to keep the downrigger upright.

Reinforce the downrigger when mounting it to your boat. It should be solid and supported before you fish. Always use properly bedded stainless steel fasteners.

Bring your gear to you when retrieving. Avoid leaning out, as sudden motion could send you overboard. Consider using a 3025 Downrigger Weight Retriever as a safety precaution.

When trailering or travelling on the water, weights should be removed, lines tensioned and brakes set. Downriggers with swivel bases should be turned to the stern; downriggers without should be locked into the upright position. Do not leave weights attached. Always remove and place in a proper holder (ie 3022 Weight Mate). Weights can easily bounce free from a seemingly safe spot and if they are still attached to your wire they can be a danger to both boat and person.

Never use heavier weights than fishing conditions require. Heavy weights reduce performance and efficiency and will shorten wire life.

Never let the wire go slack. Kinks may form and with wire may also spill over the edge of the spool, causing tangles and damage.

Never let your fishing reel spin freely while you lower your weight. Set a light drag to maintain control.

Never use nylon or other monofilament line on your Scotty Downrigger. Nylon may stretch with use and shrink back on the spool with enough force to damage the equipment. Use of nylon line will void the downrigger warranty.

Never attempt to retrieve a weighted or snagged downrigger cable by hand. Wave or boat motion could cause serious injury. Use emergency crank handle if necessary.